Isel LES4 - Troubleshooting; Table 1 - General Faults on the Linear Unit

LES
4, 5, 6
- 234xxx xxxx
57 / 62
Assembly instruction
7.4 Troubleshooting
The table below includes some general solutions to potential problems occurring when using the machine; they
can be rectified independently by the operator if necessary.
Information
If the problem can not be solved, please get in touch with the maintenance personnel or
contact our service/support department. See chapter _RS.
Fault / Problem / Error
Possible cause
Solution
see also
chapter ...
Increased running noises
- Pollution
- Missing lubricant film
- Cleaning the linear unit
- Reduce relubrication interval
Sluggishness
- Pollution
- Bracing
- Cleaning the linear unit
- Ausrichtung, Justage
Increased wear (abrasion)
- Too high load
- Missing lubricant film
- Reduce load
- Reduce maintenance interval
Increased play on guide
carriage, spindle drive
- Wear
- Too high load
- Reduction of the preload
- Reduce load
- Reduce maintenance interval
- Adjusting the preload
_RSe_3205
Table 1 - General faults on the linear unit