iSHAN YET-A2P2 - User Manual

Other manuals for iSHAN YET-A2P2

Operation Instructions21 pages

Questions and Answers

T
Taylor BenjaminAug 8, 2025
What to do if lamps are shining but no oil discharge in iSHAN Lubrication systems?
- M
  Martha DuffyAug 8, 2025
  If the lamps on your iSHAN Lubrication system are shining, but there's no oil discharge, it could be due to several reasons. First, the oil level switch might not be functioning correctly, in which case you should replace it. Second, there might be insufficient oil; add oil to the proper level. Finally, the pump motor might not be running, requiring a replacement of the pump motor.
A
amy50Aug 13, 2025
What to do if iSHAN YET-A2P2 Lubrication systems pump is working but there is no discharge?
- K
  Kimberly SharpAug 13, 2025
  If your iSHAN Lubrication system pump is working, but there's no oil discharge, first, give it about a minute to see if the oil starts flowing. If not, carefully loosen the thimble nut on the elbow joint to let out any trapped air, then tighten it back up once the oil starts flowing. If that doesn't work, disassemble the piping and check if oil discharges when the power is on. If no oil discharges, the gear pump might be blocked; try cleaning it or replacing it if cleaning doesn't solve the issue. If oil does discharge, the lubricator is fine, and the oil pipe might be choked or damaged; locate the damaged section and replace the pipe.
J
Jennifer ParksAug 18, 2025
Why the motor doesn’t run in iSHAN YET-A2P2?
- J
  Jessica HarrisAug 18, 2025
  If the motor of your iSHAN Lubrication system doesn’t run, it could be due to several reasons. First, ensure that you are using the correct voltage by checking the electricity specification and confirming compatibility with your power supply. Second, the pump might have come into contact with humidity or water; try cleaning the pump, and if that doesn't work, replace it. Third, the gear pump itself may be faulty; in this case, use only new oil.
K
Kevin ClarkAug 23, 2025
How to troubleshoot lamps not shining in iSHAN Lubrication systems?
- B
  Brandi DiazAug 23, 2025
  If the lamps on your iSHAN Lubrication system are not shining, it could be due to several reasons. First, check the leads and plugs to ensure there isn't an electricity cut-out. Second, the lamps themselves might be faulty, requiring replacement. Third, you might be using the wrong voltage, so ensure you're using the proper power supply. Finally, there could be a fault with the IC-control, necessitating a new IC-control.
C
Catherine RichardAug 28, 2025
Why is oil discharged insufficiently from iSHAN YET-A2P2 Lubrication systems?
- S
  Susan MorrisAug 28, 2025
  If your iSHAN Lubrication system is discharging oil insufficiently, it could be due to a blocked filter. Clean the oil suction set to resolve this issue. Alternatively, the wrong viscosity of oil may be in use, so ensure you are using a suitable oil.
D
David AcevedoSep 2, 2025
What to do if oil leaks at the connection of pipe adaptor and oilpipe in iSHAN YET-A2P2?
- P
  Pamela BrownSep 2, 2025
  If oil leaks at the connection of the pipe adapter and oil pipe while your iSHAN Lubrication system is lubricating, it is likely due to incorrect installation. Ensure the thimble is completely slipped over so that at least 1 mm of the pipe sticks out when inserting it into the oil adapter.