2/54
IWQ Series Service Manual
Contents
Chapter 1. Product Overview .........................................................................................4
1.1 Product Overview...............................................................................................................4
1.2 Standard Specifications .....................................................................................................4
1.3 Appearance........................................................................................................................5
1.4 Appearance of Operation Panel.........................................................................................5
Chapter 2. Installation, Placement and Setup...............................................................7
2.1 Outer Dimensions ..............................................................................................................7
2.2 Procedures of Installation and Placement..........................................................................8
Chapter 3. Each Setting Mode......................................................................................10
3.1 Configuration of Modes ....................................................................................................10
3.2 Setup Mode......................................................................................................................11
3.2.1 Setup mode list ..................................................................................................................11
3.2.2 Start-up of Setup Mode, setup, and end of setup..............................................................14
3.2.3 Input command format.......................................................................................................15
3.2.4 Output format .....................................................................................................................18
3.3 Test Mode ........................................................................................................................22
3.3.1 Start-up and end of Test Mode ..........................................................................................22
3.3.2 C1 Mode ⋅⋅ Country No. Scale No. and Span Adjustment.................................................23
3.3.3 C2 Mode ⋅⋅⋅⋅ Key check ......................................................................................................26
3.3.4 C3 Mode ⋅⋅⋅⋅ Display check (1) ...........................................................................................27
3.3.5 C4 Mode ⋅⋅⋅⋅ Display check (2) ...........................................................................................27
3.3.6 C5 Mode ⋅⋅⋅⋅ Program No. display.....................................................................................28
3.3.7 C6 Mode ⋅⋅⋅⋅ E2ROM initialization (Registration ⋅ set data/all) ...........................................28
3.3.8 C7 Mode ⋅⋅⋅⋅ Individual setup of country specifications and weighing conditions ..............29
3.3.9 C8 Mode ⋅⋅⋅ E2ROM data readout .....................................................................................29
3.3.10 C9 Mode A/D flickering check, I/F inspection mode ..........................................................30
3.4 Country No. List ...............................................................................................................31
3.5 Scale No. List ...................................................................................................................32
3.6 EEPROM Map..................................................................................................................33
3.6.1 EEPROM (0 ∼ 127) data format.........................................................................................33
3.6.2 Measurement conditions setup table .................................................................................35
To Next Page
Loading...
Need help?
General
