iSinwheel U2 - Fault Codes; Diagnostic Fault Codes; Customize Settings; Customizable Settings Guide

13
Fault codes
Customize settings
normal status
retain
brake
PAS sensor fault (riding icon)
6km/h cruise control
real-time cruise control
battery undervoltage
motor fault
throttle fault
control fault
communication receiving fault
communication transmitting fault
BMS communication fault
front light fault
Customizable parameters are as follows:
P01: odometer unit (0 is kilometre; 1 is mile)
P03: backlight brightness (1 is the weakest and 3 is the brightest)
P04: odometer resetting (press and hold "+" button to reset the odometer)
P05: unlock the speed limit (press "+" or "-" button to unlock the top speed to 32 km/h)
fault code
(decimal)
0
1
2
3
4
5
6
7
8
9
10
11
12
13
fault name
note
Not implemented here
In the power-on state, when the speed is 0 on the display
Hold and for over 2 seconds to enter the selection interface of parameter setting items;
Press or hold to switch the setting items and then press or to adjust parameters;
Hold and for at least 2 seconds to save the setting and quit the selection interface of
parameter setting items
P02: /