iSinwheel U2 - Assembly Instructions; Before Assembly; Install Kickstand

2
Check the parts and accessories carefully. If there are missing or damaged
parts/accessories, please contact online customer service support.
1x Charger
1x User Manual
User’s
Manual
2x Key
3x Hex Spanner
3x Open-end
Spanner
3. Assembly Instructions
● Please read this manual thoroughly and follow its instructions.
● Make sure all parts are intact.
● Do not install the battery or start the computer until the bike is fully assembled.
● If you have any questions or can't find the information you need in the manual, please
contact us via email at support@ebikelab.eu
Before Assembly
3.1 Install the kiskstand
● Loosen and remove the screws using
an appropriate hex key.
● Align the screw holes of the kickstand
to the kickstand mounting holes on the
bike frame. Put back on the 2 screws
with the screw heads facing outside with
an appropriate hex key.