Need help?Do you have a question about the Ismatec MasterFlex Reglo ICC and is the answer not in the manual?
Details warranty coverage, terms, and conditions for the Reglo ICC pump.
Identifies and describes the ports and connectors on the pump's rear panel.
Provides information on the pump's power input requirements and supply.
Explains the function of each button on the keypad and the LCD display interface.
Illustrates and describes the meaning of icons displayed on the Reglo ICC screen.
Guides users on navigating menus and modifying pump settings via the keypad.
Describes the STATUS menu screens displaying current pumping parameters and totals.
Details how to set pumping parameters like mode, rate, and direction for each channel, including various modes.
Covers setting tubing ID and backsteps for drip-free dispensing.
Guides on calibrating each channel independently for precise fluid delivery.
Allows selection of display language and resetting pump to factory defaults.
Provides step-by-step instructions for correctly installing tubing into the pump.
Explains the 'Remote Mode' and 'Temperature Alarm' information screens.
Specifies the maximum allowable differential pressure for pump operation.
Recommends actions when the pump is not in use to prolong tubing life.
Lists part numbers and materials for ordering replacement cassettes and tubing.
Describes the chemical resistance and properties of POM-C and PVDF cassette materials.
Notes the recommendation against using pressure lever cassettes with this pump.
Introduces the serial communication protocol, baud rate, and data format.
Explains the communication methods via USB or RS-232 interfaces.
Defines the structure and termination of messages used in the protocol.
Explains how pumps and channels are addressed in communication commands.
Defines the symbols and characters used within the protocol messages.
Describes various data formats including Boolean, Direction, Discrete, Fractional, Volume, Time, and String.
Specifies the format for language selection using a single numeric character.
Explains the status response indicating success or failure of a command.
Details the data response format for returning parameter values.
Command format for setting the pump's unique address.
Structure of commands used to get or set pump parameters.
Demonstrates serial protocol version retrieval and event message enabling.
Shows commands for starting, stopping, and setting pump direction.
Illustrates setting pump modes, rates, volumes, and times.
Demonstrates setting tubing diameter and backsteps for precise dispensing.
Provides examples for calibrating target volume, measured volume, and time settings.
Shows examples for managing firmware, serial number, and language.
Illustrates channel stop and status update event messages received from the pump.
Details regarding the Declaration of Conformity requirements and content.
Lists European directives to which the product complies.
Specifies the international safety and performance standards met by the product.
Defines the conditions under which the CE marking and Declaration of Conformity are valid.
Outlines safety requirements for equipment connected to the Reglo ICC.
General| Pump Type | Peristaltic |
|---|---|
| Power Supply | 100-240 VAC, 50/60 Hz |
| Channels | 1 to multiple, depending on pump head |
| Communication Interface | RS-232 |
| Hose/Tubing Compatibility | Various, depending on pump head |
To Next Page
