www.123filter.com | (678) 261-7611 | support@123filter.com Page
8
Product Assembling and Installations
1). Before Installation
Ensure there is enough space at the desired location for the system and to change filters
safely. Contaminated water will run out of the drain line, so be sure to consider this.
Verify no parts are missing from the package. Contact iSpring if any part is missing or
defective.
Tools required for assembly:
Figure 5. Recommended Tools
2). Assembling the Machine Head
Remove the screws on the clamps located on both ends of the stainless-steel membrane
housing. Also, remove the caps on both ends.
Verify the O-rings on both caps (4 in total) are correctly in place.
Take the RO 1000G out of its package and place it in the stainless-steel membrane housing.
Pay careful attention to the direction of the arrow on the RO membrane; it must be the
same as the direction of the stainless-steel membrane housing.
Replace the caps on the stainless-steel membrane housing and screw the clamps in place.
Pay attention to the ends of the caps.
Insert the PE tube into the quick connector on the lower left side. You do not need to insert
the upper quick connector on the left side at this point. After the first three-stage filter is
flushed with water, install the quick connector on the upper side. Then rinse for 3-5
minutes before connecting the PE tube to the water inlet of the RO membrane. This serves
to prevent damage to the RO membrane from the activated carbon particles washed out
from the first rinse.
To Next Page
Loading...
Need help?
General
