12. Adding a new User Password
You can add a new User Password by doing the following:
1. Enter the Admin Mode (refer to page 9 for details).
2. Press and hold + 1 until the LED indicator light flashes BLUE intermittently.
3. Enter a User Password and press (a minimum of 6 digits and a maximum
of 16 digits). The LED indicator light will flash GREEN three times.
4. Re-enter the new User Password and press . If the LED indicator light stays
solid GREEN for two seconds and then solid BLUE, the User Password was
added successfully.
13. Deleting the User Passwords
You can delete all User Passwords by doing the following:
1. Enter the Admin Mode (refer to page 9 for details).
2. Press and hold 7 + 8 + for five seconds until the LED indicator light
flashes BLUE intermittently. After the LED indicator light will flash GREEN
three times and then BLUE intermittently.
3. Press and hold 7 + 8 + a second time for five seconds until the LED indicator
light goes on solid GREEN for two seconds and then back to solid BLUE, this
indicates that the User Passwords were deleted successfully.
14. Changing the User Password
You can change the User Password by doing the following:
1. Enter User Mode (refer to page 8 for details).
2. Press and hold + 1 until the LED indicator light flashes RED.
3. Enter your old password and press . The LED indicator light will turn
GREEN, then change to flashing BLUE.
4. Enter the new password and press (The Password must be a minimum
of 6 digits and a maximum of 16 digits). The LED indicator light will flash
GREEN three times.
5. Immediately re-enter the new User Password and press . The LED indicator light
will stay solid GREEN indicating that the User Password has been changed successfully.
To Next Page
Loading...
Need help?
General