Be sure to review the following information before you begin to use the diskAshur SSD.
Caution: Use only the included cables with your diskAshur SSD. You might damage the drive if you
use a cable not included with the diskAshur SSD.
2. Connecting the diskAshur SSD
1. Attach the integrated USB cable of the diskAshur SSD to an available USB port
on your computer, as shown below.
2. The diskAshur SSD LED indicator light should glow RED.
Note: If the LED indicator light does not power, use the included USB Y-cable.
Refer to directions on the following page.
To Next Page
Loading...
