1A-188 Engine Control System (4HK1)
5
1. Reconnect all previously disconnected
harness connector(s).
2. Clear the DTCs with a scan tool.
3. Turn OFF the ignition for 30 seconds.
4. Start the engine.
5. Operate the vehicle within the Conditions for
Running the DTC. You may also operate the
vehicle within the conditions that you
observed from the Failure Records.
Did the DTC fail this ignition?
—
Go to Step 3 Go to Step 6
6
Observe the DTC Information with a scan tool.
Are there any DTCs that you have not
diagnosed?
—
Go to DTC List System OK
Step Action Value(s) Yes No
LG4HKED-WE-0871.book 188 ページ ２００７年１１月２９日 木曜日 午後６時２９分
To Next Page
Loading...