EasyManua.ls Logo

Isuzu 2008MY N Series - Page 194

Isuzu 2008MY N Series
404 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Engine Control System (4HK1) 1A-191
2
1. Install a scan tool.
2. Turn OFF the ignition for 30 seconds.
3. Start the engine.
4. Monitor the DTC Information with a scan tool.
Is DTC P0697 also set?
Go to DTC P0697 Go to Step 3
3
1. Start the engine and fully warm up (allow
engine coolant temperature to reach at least
80°C [176°F]).
2. Accelerate the engine between idle and
W.O.T. (accelerator pedal full travel) many
times while observing the Exhaust
Temperature Sensor 2 parameter with a scan
tool.
Is the Exhaust Temperature Sensor 2
parameter more than the specified value?
4.8 volts
Go to Step 4
Go to Diagnostic
Aids
4
1. Turn OFF the ignition.
2. Disconnect the exhaust temperature sensor 2
harness connector.
3. Connect a DMM between the signal circuit
(pin 1 of J-35) and a known good ground.
4. Turn ON the ignition, with the engine OFF.
Is the DMM voltage more than the specified
value?
5.5 volts
Go to Step 5 Go to Step 6
5
Important: The exhaust temperature sensor 2 may
be damaged if the sensor signal circuit is shorted to
a voltage source.
1. Test the signal circuit between the ECM (pin
74 of J-14) and the exhaust temperature
sensor 2 (pin 2 of J-35) for a short to battery or
ignition voltage.
2. Repair the circuit(s) as necessary.
Did you find and correct the condition?
Go to Step 15 Go to Step 14
6
Connect a 3-amp fused jumper wire between the
signal circuit and the low reference circuit (pins 1
and 2 of J-35).
Is the Exhaust Temperature Sensor 2
parameter less than the specified value?
0.1 volts
Go to Step 10 Go to Step 7
7
Connect a 3-amp fused jumper wire between the
signal circuit (pin 2 of J-35) and a known good
ground.
Is the Exhaust Temperature Sensor 2
parameter less than the specified value?
0.1 volts
Go to Step 9 Go to Step 8
8
1. Test the signal circuit between the ECM (pin
74 of J-14) and the exhaust temperature
sensor 2 (pin 2 of J-35) for an open circuit or
high resistance.
2. Repair the circuit(s) as necessary.
Did you find and correct the condition?
Go to Step 15 Go to Step 12
Step Action Value(s) Yes No
LG4HKED-WE-0871.book 191 ペー 2007年11月29日 木曜日 午後6時29

Table of Contents

Related product manuals