EasyManuals Logo

Isuzu 2008MY N Series User Manual

Isuzu 2008MY N Series
404 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #351 background imageLoading...
Page #351 background image
1A-348 Engine Control System (4HK1)
Fuel System Checks Inspect the fuel system for the following conditions. Refer to Fuel System
Check chart and appropriate procedure in Section 1D Engine Fuel.
Air in the fuel system.
Water contamination in the fuel.
Fuel waxing or icing.
Fuel filter clogging.
External fuel leaks or high engine oil level.
Fuel leak off from the fuel pressure limiter valve and fuel injectors.
Fuel lines between the fuel tank and fuel supply pump for being crushed,
kinked, tightness, cracks and plugged.
A plugged fuel tank vent hose.
Inside the fuel tank for any foreign material that may be getting drawn into
the fuel line pickup causing a blocked condition.
Fuel supply pump operation.
Notice: The fuel supply pump must be timed to the engine and adjustment
value must be learned to the ECM.
Perform the Cylinder Balance Test with a scan tool.
Perform the Injector Force Drive with a scan tool.
Observe the FRP Regulator Feedback current on the scan tool.
Air Intake System Checks Inspect the air intake system for the following conditions.
Air cleaner, air intake ducts and charge air cooler for a restriction, holes, or
leaks.
A restriction in the turbocharger inlet duct.
Intake throttle valve for a stuck condition.
A restriction or leak in the intake manifold.
Exhaust System Checks Inspect the exhaust system for a possible restriction. Refer to Exhaust System
in Section 1G Engine Exhaust.
Engine Mechanical Checks Inspect the engine mechanical for the following conditions. Refer to the
Section 1B Engine Mechanical.
Poor cylinder compression.
Improper mechanical timing (timing gear).
Improper valve gap.
Broken or weak valve springs.
Worn camshaft lobes.
Electrical System Checks Inspect the engine electrical for the following conditions. Refer to the Engine
Electrical section.
Glow plug control system operation. Refer to Glow Control System Check
in this section.
Slow cranking speed.
Weakened batteries.
Checks Action
LG4HKED-WE-0871.book 348 ペー 2007年11月29日 木曜日 午後6時29

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Isuzu 2008MY N Series and is the answer not in the manual?

Isuzu 2008MY N Series Specifications

General IconGeneral
BrandIsuzu
Model2008MY N Series
CategoryControl Systems
LanguageEnglish

Related product manuals