Engine Control System (4HK1) 1A-377
• Model
• Model year
• Engine type
• Model designator
• Destination code
• Transmission type
9. Verify your selection on the Summary screen.
Notice: Refer to Service Bulletin and Description
column before service programming is performed if
the bulletins are listed along with the calibration
files.
Notice: Select Cancel if you receive a message
stating that the calibration selected is already the
current calibration in the ECM and reprogramming
with the same download is not allowed.
10. Click "Reprog".
11. The Transfer Data screen will appear until the
progress bar reaches 100%.
Some warning lamp may turn ON or blink while
programming the ECM since communication
between the ECM and other modules are
interrupted. Clear DTC in any module after
programming.
12. Close the application and return to the TIS
application selection screen after the download is
complete.
13. Turn OFF the ignition.
14. Turn OFF the scan tool and disconnect from the
vehicle.
LG4HKED-WE-0871.book 377 ページ ２００７年１１月２９日 木曜日 午後６時２９分
To Next Page
Loading...