Isuzu 4LE2 - Drain Plug Type

5-10
INSPECTION AND MAINTENANCE
6. Remove the oil dipstick and carefully fill the
specified engine oil into the oil filler.
7. Install the oil dipstick and the oil filler
cap, and start the engine 5 minutes after
refueling, and then let it idle. At this time,
check whether any oil leak is found around
the oil filter and oil drain cock.
ADVICE
Do not perform abrupt engine idling, which
may cause an engine failure.
•
8. Stop the engine, wait for 10 - 20 minutes,
and then check the oil level with the oil
dipstick.
Drain Plug Type
1. Clean around the oil filler cap so that foreign
matter does not enter. Remove the oil filler
cap.
2. Place a container for receiving the oil
beneath the oil pan and the oil filter.
3. Loosen the oil drain plug to remove it, and
then drain the oil.
4. When the oil is completely drained out,
replace the gasket of the oil drain plug with a
new one, and then install the oil drain plug.
5. Tighten the oil drain plug.
Drain plug tightening torque
78.5 N·m (8.0 kgf·m/58 lb·ft)
ADVICE
Make sure to wipe off any dirt on the oil
drain plug before installing it.
•
6. Remove the oil dipstick and carefully fill the
specified engine oil into the oil filler.
7. Install the oil dipstick and the oil filler
cap, and start the engine 5 minutes after
refueling, and then let it idle. At this time,
check whether any oil leak is found around
the oil filter and oil drain plug.
Oil drain plug
Drain plug type
Oil drain plug
Drain plug type
IDE-6450A4500781ALL.indd5-10IDE-6450A4500781ALL.indd5-10 2014/04/1814:20:002014/04/1814:20:00