ItaldibiPack Leo - Using the Machine: Film Tension and Shutdown; Film Tension Adjustment and Machine Shutdown

Il presente manuale è di proprietà di ogni riproduzione, anche parziale, è vietata.
LEO Instructions
Edition: 01/2016 - Revision: 01/16
Switching off the robot
Press ON/OFF andturnthekeyanti-clockwise,toswitch-offthemachine.
CAUTION
For safety reasons, DO NOT switch-off the machine when the lm roll holder car riage
is not in low position!
IMPORTANT
Constantly check the battery charge status.
Recharge it every time the display shows a voltage below
18V.
In the event the battery voltage drops too low, the supplied
battery charger (electronic type) is unable to recharge
them.
It will be necessary to remove the cover and use a traditional battery
charger.
Each battery must be disconnected and separately powered at 12V.
Operation to be performed by an electrical maintenance technician.
27
USING THE MACHINE
continuedOperation
Film tension adjustment
If the lm tension is too low, the touching arm moves too far away from the pallet
edge, caus ing the robot to rotate on itself with the subsequent intervention of the
safety devices.
Ifneeded,adjustthetensionofthelmby
actingtheknob(Fig.27).
Clockwiserotation=Tension increase
Anti-clockwiserotation=Tension decrease
5-07