To Next Page

To Previous Page

Basic Operation

Category Parameter Initial Value

Upper limit of voltage: Vh, and

lower limit of voltage: Vl

Upper limit value: One

percent of the rated

voltage of the

instrument

Lower limit value: 0

Upper limit of current: I+, and

lower limit of current: I-

One percent of the

rated current of the

instrument

Upper limit of power: P+, and

lower limit of power: P-

Rated power value of

the instrument

[On/Off] status Off

Config

Mode CV

Speed High

V-Rise Time/I-Rise Time 0.1s

V-Fall Time/I-Fall Time

Output Res 1000

On Delay/Off Delay 0

• Last: Indicates when powered on, the instrument will remain the same

parameter settings and output status as last time you powered off the

instrument.

• Last+Off: Indicates when powered on, the instrument will remain the

same settings as last time you powered off the instrument, but the output

status is Off.

4. After the parameter settings are complete, press [Enter].

For example, Last is selected, and the voltage value is set to 20V. After the

instrument is powered off and then powered on, the voltage displayed on the

interface is 20V.

5.7 Sense Function (Sense)

This menu item is used to switch the power supply to local measurement or re-

mote sensing.

158

ITech IT6005C-80-150 User Manual

Questions and Answers: