ITech IT6724 - System Self-Check Procedures

IT6700 User manual
User Manual
15
3) Verify that the correct power-line fuse is installed.
If the fuse was damaged, please see the table below to replace the fuse for your power
supply.
Model
Fuse Specifications（220VAC） Fuse Specifications（220VAC）
IT6723/IT6723B/IT6723C/I
T6723H/IT6723G
T15AT 250V T15AT 250V
IT6724/IT6724B/IT6724C/I
T6724H/IT6724G
T15AT 250V Not available
IT6726H/IT6726G/IT6726V
/IT6726B
T20AT 250V Not available
4) How to exchange the fuse
Open the fuse box:
Use a screwdriver to push and turn the fuse box on the rear panel of the power supply,
refer to the below picture. After the fuse box is opened, you can see the fuse in it. Please
replace with a fuse of the same specification.
When install, use a screwdriver to push and turn the fuse box. Refer to the picture
below.
3.1.2 System self-check
After power on normally, the supply will enter self check test first.
If the power supply is normal, then VFD will display the output voltage and current
status as below:
About 1 second after power on，If the EEPROM was damaged or the latest operation
data in EEPROM was lost, the VFD will display as below:
If the last power status in EEPROM is lost, then VFD will display information (about 1 S)
as below:
EEPROM FAIL
SYST LOST
OFF
0.0V 0.00A