Automatic Test Function
Copyright © Itech Electronic Co., Ltd. 50
Set the power-on state to automatic test
1. Press [Shift] + [8] (System) to enter the system menu.
POWER-ON BUZZER
2. Press the right key to the RUNMODE, and press [Enter].
RUNMODE DEFAULT
3. Press the left or right key to select PROG_TEST and press [Enter], the
menu will return to RUNMODE.
RUN <PROG_TEST
4. Press [Esc] to exit.
P01
Note
To exit the automatic test mode, press [Shift] + [8] (System) to enter
the system menu and select RUNMODE as NORMAL.
Recall the test file to run
The following method can quickly recall the existing test file from the EEPROM
and test it after the instrument is powered on.
Operate in automatic test mode:
1. Press [Shift] + [Enter] (Recall).
0.0000V 0.000A
RECALL PROGRAM=1 (0~10)
2. Press the number keys to select the group and press [Enter].
0.0000V 0.000A
P01
3. If the start voltage (Start) is set to 0 during the editing process, press [Shift]
+ [.] (Trigger) to trigger.
If the start voltage (Start) is set to a non-zero value, connect the DUT to
start the test. The automatic test step will be displayed on the VFD and
FAULT or PASS will be displayed after the test is over.
0.0000V 0.000A
P01-01 2.100A
Note
Press [Shift] + [0] (Pause) to stop running the automatic test. Press
to continue testing.
To Next Page
Loading...
Need help?
General
