ITOH DENKI IB-P05F-P User Manual

(3) When the network is configured only with IB controllers
Set each IB as a master, and download ladder logic into each of them. The control can be
performed without connecting the PC or PLC.
(4) When one IB controls multiple connected IBs
Set an IB as a master, and set the other IBs as slaves. The master IB controls its own zone and
the zones of the slaves. Up to seven slave IBs can be set for one master IB.
IB-P05(master)
(w/ ladder)
IB-P05(master)
(w/ ladder)
IB-P05(master)
(w/ ladder)
IB-P05(master)
(w/ ladder)
Communication between IB
(such as sensor information)
Communication between IB
(Motor RUN command)
Co
mm
u
ni
cat
i
o
n
bet
w
ee
n IB
(
suc
h
as se
n
so
rinf
o
rm
at
i
o
n
)
IB-P05(slave)
Seven IBs in maximum
IB-P05(master)
(w/ ladder)
(w/o ladder)
IB-P05(slave)
(w/o ladder)
IB-P05(slave)
(w/o ladder)
IB-P05(slave)
(w/o ladder)
Original notice - A1.2
15
Controlling IB-P05
IB-P05 Technical documentation
1. Introduction

ITOH DENKI IB-P05F-P Specifications

General

Brand	ITOH DENKI
Model	IB-P05F-P
Category	Controller
Language	English