Installation
1. Assemble the camera with mounting cradle and fix it to the window
shield. (Clean the window shield before fixing it)
2. Put the connecting cable into the camera port of main unit and
connect it with each of the cameras.
3. Please install two cameras (Front and Rear) in the same way as above
procedure.
4. Put the power cable into the power port and connect it with car
battery fuse box. The product requires constant 12V DC power supply.
5. Insert the SD memory card into the slot of main unit.
6. Check all connections and power on the unit for operation to run a
TEST to make the sure system is functioning properly. After the test is
complete you can continue to mount the main control unit and
arrange cameras (see next page).
12
To Next Page
Loading...
