Operation of the product
1. Turn on the power of the vehicle, the POWER LED turns on. 3 low to
high tone beep sounds will be heard after 30 seconds when the POWER
LED turns on, the product starts recording. The video and audio data
are continuously recorded and stored into SD memory card.
2. When impact of collision, lightning acceleration or sudden brake is
detected by the built-in impact sensor, the LED indicator of camera
blinks three times and the recorded data is stored in SD memory card
as event file.
3. When turning off the power, the product processes the last data file for
5~10 seconds and turns off. This will occur if device is wired to a
constant 12V/24V supply. The device will give three beeps (high to low
toned). Please do not remove the SD memory card before the device
has properly shut down.
16
* Note: In case the Shock-Sensing Sound Alarm is set to ON at User Setting, 2-scale beep tone (beep-beep) will sound
with LED indication and save as Event Image. However, in order to prevent malfunction of 3-axis acceleration sensor, if
the Event happens within 10 seconds after Alarm tone sounds, Alarm tone won’t sound but just LED blinks 3 times and
record as Event Image.
To Next Page
Loading...
