9. DTMF PROGRAMMING
The ADRA 1000/2000 is programmed by telephone using DTMF tones.
For the ADRA 2000, both lines can be programmed and recorded using DTMF
tones from one of the lines.
Note: A confirmation tone is heard every time a programming command is
entered.
9.1 Entering and Exiting the Programming Mode
The ADRA 1000/2000 does not handle calls when in programming mode.
To enter the programming mode:
1. Call the ADRA 1000/2000 Ext. from any touch-tone telephone.
2. Wait until the ADRA 1000/2000 answers and plays the opening greeting, or a
clear tone is heard (if no greeting is recorded). Next, dial *900.
3. Dial the System Administrator’s password (the default password is 1234) to
enter the programming mode.
To exit the programming mode:
• Dial *900.
ADRA 1000/2000 Installation and Programming Manual 9-1
To Next Page