ITW Foxjet Marksman Matrix - Define: Bitmap Settings; Define: Shift Codes

Section 6: BoxWriter© Matrix & Elite Editor
Marksman Matrix & Elite
2465-623 User Manual Rev F Page 36
Bitmap Settings
To define bitmap set-
tings, select
Define >
Bitmap settings
.
The "Bitmap editor"
field defines the pro-
gram used to edit bit-
maps. By default, it is
Microsoft® Paint. To
change it, browse
and select the pro-
gram to be used.
Label Editor
Used to configure software when the Marksman Matrix or Elite is used with a Label Appli-
cator.
Shift Codes
To define shift codes, select
Define > Shift codes. Shift
codes are used by Shift ele-
ments.
The shift code’s length must be
from 1 to 15 characters. The
code’s times must be in order
from least to greatest (i.e., code
1 cannot be later than code 2 or
3).
Line:
This determines the pro-
duction line for the shift code
definitions.
Select the appropriate production line. Enter the shift start times and any user-defined
codes. The shift start times must be entered in 24-hour format. The shift code may contain
a maximum of 15 alphanumeric characters.
The sample dialog shows shift 1 starting at 7:00 AM, shift 2 starting at 3:00 PM and shift 3
starting at 11:00 PM.