3. Filter Button
The filter LED light will illuminate after approximately 250 hours of operation to remind you to clean the
air filter to obtain maximum performance and efficiency. To reset after cleaning the filter, press the Filter
button and the light will go off.
4. Turbo Button
Press to select either high (“Turbo”) or normal fan speed. Choose Turbo operation for maximum moisture
removal.
5. Cont. Button
Press to set the dehumidifier to run continuously without a timer. The continuous mode light will turn on.
To stop continuous operation, press the Cont. Button and set the desired humidity level.
6. Timer Button
Press to activate the timer function for automatic start or stop. Use the left < and right > buttons to
enter desired times in 0.5 hour increments, following the instructions in the “Setting the Timer” section.
7. LCD Display and Left < / Right > Buttons
The display shows the humidity settings and the auto on/off time settings as they are being programmed,
then defaults to displaying the actual room humidity level.
8. Power Button
Turns the unit on and off.
Automatic Features
• Auto shutoff: The unit will automatically shut off when either the reservoir is full or the set humidity is
reached. Wait 3 minutes before resuming operation.
• Auto defrost: When frost builds up on the evaporator coils, the compressor will cycle off and the fan
will continue to run until the frost evaporates. Defrost time may vary. If the dehumidifier freezes up, turn
the appliance off for few hours and then restart. The appliance will not operate satisfactorily if the room
temperature is below 41°F (5°C).
• Full reservoir indicator: The appliance will run continuously until the set RH% is reached or when the
reservoir is full. When the reservoir is full, the Full indicator light will illuminate and the dehumidifier will
stop operating. Remove and empty the reservoir and replace it in its proper position. The unit will start
operating again.
• Auto restart: If the power is cut unexpectedly, the unit will restart with the previous settings when
power resumes.
LED Display
Shows the set humidity % level from 35% to 85%; then shows the actual room humidity % (+5%
accuracy) from 30%RH (relative humidity) to 90%RH.
Also shows the Auto Start/Stop Time (0 –24 hrs.)
To Next Page
Loading...
Need help?
General
