8 CONFIGURE NETWORK
8.1 Configuring General Settings
1. Network Access: Here you can choose between the three different types of networks that the NVR
can be connected to. The three types of networks are:
1) DHCP: DHCP (Dynamic Host Configuration Protocol) is a system where one device on your
network (usually a router) will automatically assign IP addresses to devices connected to the
network.
2) STATIC: Static networks require all devices to have their IP addresses manually defined, as there
is no device dedicated to automatically assigning addresses.
3) PPPoE: An advanced protocol that allows the NVR to be more directly connected via a DSL
modem. This is an option for advanced users only.
2. If you select Static in Network Access, you will need to input IP Address, Subnet Mask, Default
Gateway and DNS information.
To Next Page
Loading...