associated channel. If you’re not using all the inputs on your NVR, then some channels will be in
“permanent” Video Loss state. Just be sure that you don’t enable a video loss action for these channels.
1. Channel: Which channel/camera you’d like to set the Video Loss behavior for.
2. Enable: Whether the selected channel has video loss monitoring active or not.
3. Schedule: Alters when the current Video Loss Action will be active.
4. Action: The action you’d like the NVR to take when this event occurs. It’s set in the same way as
the Action for any other event.
9.3 Detecting Exception
Setting exceptions allow the NVR to alert you when irregular events occur. These events include:
To Next Page
Loading...
Need help?
General