14
Step 2:
Mounting the spacer
The spacer (45) can be mounted to the rear of the
furnace with the help of the fastening pin intend-
ed for this purpose.
Press the spacer strongly against the rear of the
furnace. For safety reasons, the spacer must
always be mounted.
Secure the cooling tray (26) with the two screws
(27) including the silicone washers (28).
Place the cooling tray (26) on the frame plate (5).
Make sure that the cooling tray is correctly posi-
tioned on the frame plate and that the danger
symbols are visible from above.
27
28
26
5
To Next Page
Loading...
