IVT AirModule E 9 - Page 21

64 pages

To Next Page

To Previous Page

Installation

AirModule –6 720 813 268(2014/10)

Fig. 17 Outside temperature sensor positioning

(min 2m)

6 720 809 156-23.1I

Main Page

Default Chapter2
- Table of Contents2
1 Key to Symbols and Safety Instructions3
- Key to Symbols3
- General Safety Instructions3
2 Standard Delivery4
3 General4
- Information about the Heat Pump4
- Application Area4
- Heating System Minimum Volume and Operation4
- Type Plate5
- Transport and Storage5
- Heat Pump Module Positioning5
- Checks before Installation5
- Connection Principle5
4 Technical Information6
- Technical Information - Heat Pump Module6
- System Configurations7
5 Measurements, Positioning Distance, and Pipe Connections11
- Heat Pump Module Dimensions and Connections11
- Pipework13
6 Regulations13
7 Installation14
- Detailed Discharge Pipe Installation Requirements (Combi Model)14
- Preparatory Pipework14
- Positioning14
- Checklist14
- Water Quality15
- Heating System Flushing15
- Operation Without Heat Pump (Stand-Alone)15
- Installation with Cooling15
- Installation with Solar Heater (Only Solar Model)16
- Installation with Pool16
- Connecting the Heat Pump Module to the Heat Pump17
- Connecting the Heat Pump Module to the Heating System and Tap Water18
- Low Energy Pump for Heat Transfer Medium (PC0)19
- Circulation Pump for the Heating System (PC1)19
- DHW Circulation Pump PW2 (Accessory)19
- Insulation19
- Several Heating Circuits (Mixing Valve Module Accessory, See Separate Instructions)19
- Installation of Condensation Sensor (Accessories)19
- Temperature Sensor Installation20
- Heat Pump and Heat Pump Module Filling22
8 Electric Installation23
- Can-Bus23
- Ems-Bus23
- Printed Circuit Board Handling24
- External Connections24
- Accessories24
- Connecting the Heat Pump Module24
- Electric Box Layout25
- Power Supply Heat Pump and Heat Pump Module 9 Kw 3N29
- Power Supply Heat Pump and Heat Pump Module 15 Kw30
- Installer Module Circuit Diagram31
- Heat Pump/Heat Pump Module Circuit Diagram32
- Connection Option EMS Bus33
9 User Interface34
- Product Description34
- Important Notices on Usage34
- Optional Accessories34
10 Basic Principles of Operation35
- Key and Symbol Overview35
- Display Symbols Overview36
- Using the Service Menu37
- Service Menu Overview38
11 Commissioning38
- General User Interface Commissioning38
- System Commissioning Via Configuration Wizard39
- Commissioning Other Settings40
- Performing the Function Test40
- Check Monitored Values40
- System Handover40
12 Service Menu41
- Heat Pump Settings42
- Booster Heater Settings43
- Settings for Heating/Cooling44
- DHW Settings52
- Pool Settings53
- Solar System Settings53
- Hybrid System Settings53
- Anti-Seizing Protection Settings53
- Diagnostics Menu54
13 Troubleshooting55
14 Heat Pump and Heat Pump Module Venting57
15 Heat Pump Module Components Replacement58
16 Function Check58
- Set Heating System Operating Pressure58
- Pressure Switch and Overheating Protection58
- Operating Temperatures58
17 Environmental Protection59
18 Maintenance59
19 Connection for IP Module61
20 Commissioning Protocol62

IVT AirModule E 9 - Page 21

Table of Contents

Related product manuals