EasyManua.ls Logo

J.P. Instruments EDM-350 - User Manual

Default Icon
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Approved Installation Manual for the Experimental Report No 104
EDM-350 Page 1 of 46 Rev A
Advisory Engine Data Management System Date 7-10-2021
TABLE OF CONTENTS
Section Page
1.
Revisions ______________________________________________________________________________________ 2
2. Read This First _________________________________________________________________________________ 2
3. Operation and Abbreviations ______________________________________________________________________ 5
4. Remote Alarm Light EDM 350 _____________________________________________________________________ 6
5. Locating and Installing the Indicator Display (Alert Light) _______________________________________________ 9
6. Routing the Wiring Harnesses _____________________________________________________________________ 10
7. Pressurized Aircraft wire Routing __________________________________________________________________ 11
8. Power Connection ______________________________________________________________________________ 11
9. Probe Wiring __________________________________________________________________________________ 11
10. Exhaust Gas Temperature Probe (EGT) Installation ___________________________________________________ 12
11. Cylinder Head Temperature (CHT) Probe Installation __________________________________________________ 13
12. Radial Engine CHT (spark plug gasket) _____________________________________________________________ 13
13. Outside Air Temperature (OAT) Probe Installation ____________________________________________________ 13
14. Oil Temperature Probe Installation ________________________________________________________________ 14
15. Oil Pressure Sensor Installation ___________________________________________________________________ 14
16. Fuel Pressure Sensor Installation using combination sensor _____________________________________________ 15
17. Ammeter Shunt Installation _______________________________________________________________________ 16
18. General Fuel Flow Transducer Installation __________________________________________________________ 17
19. Fuel Level Sender Wiring Types ___________________________________________________________________ 18
20. Fuel Flow Totalizer, Refuel Question _______________________________________________________________ 24
21. GPS Interface _________________________________________________________________________________ 24
22. Manifold Pressure (MAP) Sensor __________________________________________________________________ 24
23. RPM Sensor installation _________________________________________________________________________ 25
24. EDM-350 Specifications and Limitations ____________________________________________________________ 27
25. EMI Radio Test and functional check: ______________________________________________________________ 28
26. Component Parts _______________________________________________________________________________ 29
27. Weight and Balance Data ________________________________________________________________________ 31
28. Pilot Programming _____________________________________________________________________________ 31
29. Programming the HP Constant ____________________________________________________________________ 34
30. Programming the MAP __________________________________________________________________________ 34
31. Selecting Fuel Pressure Type _____________________________________________________________________ 35
32. Customizing Non-Primary Data (EDM350 only) ______________________________________________________ 35
33. K Factor ______________________________________________________________________________________ 35
34. Fine tuning the K Factor _________________________________________________________________________ 36
35. Adjusting the K Factor___________________________________________________________________________ 37
36. Programming Accumulate Trip Total _______________________________________________________________ 37
37. Trouble Shooting _______________________________________________________________________________ 38
38. GPS Interface Diagnostics _______________________________________________________________________ 39
43. Connector Pin Assignments on EDM, J1 through J5 ___________________________________________________ 40
44. J3 RPM, MP, Oil-P _____________________________________________________________________________ 43
45. Appendix A Connector Pin Assignments on EDM, J1-J2 Only with ARINC 429 _______ Error! Bookmark not defined.
46. Appendix B ICA _________________________________________________________ Error! Bookmark not defined.
The Owner of the EDM-350 must keep this manual
J.P. INSTRUMENTS
PO BOX 7033
HUNTINGTON BEACH CA
Last printed 7/19/2021 4:28:00 PM
Question and Answer IconNeed help?

Do you have a question about the J.P. Instruments EDM-350 and is the answer not in the manual?

J.P. Instruments EDM-350 Specifications

General IconGeneral
ManufacturerJ.P. Instruments
Display TypeLCD
Display Size3.5 inches
Resolution320 x 240 pixels
Input Voltage10 to 30 VDC
ApplicationEngine Monitoring
Operating Temperature-20°C to +55°C
CertificationsFAA Approved (STC & PMA)
Number of Cylinders SupportedUp to 9 cylinders

Related product manuals