Approved Installation Manual for the Experimental Report No 104
EDM-350 Page 31 of 46 Rev A
Engine Data Management System Date 7-10-2021
27. Weight and Balance Data
Indicator PN 350000-(xxx) EDM-350
EGT / TIT / CDT / IAT / OAT probe
CHT / Oil Temperature probe
4/6 Cylinder Harness 8 ft.
28. Pilot Programming
To start the Pilot Program procedure, ensure no alarms are being displayed in the message area. If this is the case,
STEP to clear all faults first, then simultaneously hold the STEP and LF buttons for five seconds. You will see the word
PROGRAM for two seconds and then the sequence shown in the chart below.
Tap the STEP button to advance to the next item in the list. Hold the STEP button to step back to the previous item.
Tap the LF button to select alternate values of that item. Simultaneously hold both STEP and LF to exit.
next item
sequences
through
Comments
Stays on for two seconds.
Tap LF to change fuel status. Exits program
mode when done.
Index rate (pause time in seconds) in the
Automatic Mode. 0 disables the Automatic
NO: When Refuel mode used on EDM, total fuel
used is reset to 0.
YES: accumulate total fuel used rather than reset
to 0 at each refueling. See page Error!
This allows a choice between Digital or Analog
fuel gauges. Digital will show a digital quantity
FLOW
MONITORING
YES ⇔
NO
Only appears when digital gauges are chosen.
(This feature compares the fuel totalizer value
against the strip gauge total and alarms if it’s
greater than 5 gal.) Only available with 2 tank
aircraft with AUX = 0.
DISPLAY IN
1’S
1?N ⇔
EGT
Y—Yes—sets the digital display to one-
degree resolution; N—No—sets 10°. (10°
resolution is easier to interpret the EGT’s.)
Tap C to display OAT in Celsius, F to display in
Fahrenheit. Hold STEP and LF for 5 seconds to
ADJUST the OAT calibration.
ADJUSTMENT
MINUS
Adjust the indicated temperature up or down by
up to 10° using PLUS or MINUS. For example,
OAT+3 adjust the OAT 3° higher.
To Next Page
Loading...
Need help?
General
