Approved Installation Manual for the Experimental Report No 104
EDM-350 Page 30 of 46 Rev A
Engine Data Management System Date 7-10-2021
26.6 Component Parts list for OIL Temperature probe (KIT 1250)
1 P/N 400509 OIL probe
1 AN900-10 crush washer
2 Ring Terminals
2 Screws and Nuts 6-32 X 1/4"
1 Fiberglass tube 3/8” x 5”
26.7 Component Parts list for Oil Pressure sensor KIT 1460
1 P/N 159936A Oil Pressure sensor
1 P/N 159961 Clamp, Loop Cushioned
1 P/N 174402 Connector Pack 3 Pin and Terminals
26.8 Component Parts list for Kit 1480 Differential Fuel Pressure (only if required by POH)
1 P/N 159938 Fuel pressure sensor
1 P/N 159961 Clamp, Loop
Cushioned
1 P/N 174204 Connector MS 3116F8-4S
26.9 Component Parts list for ampere shunt Kit 1300
1 P/N 159920 100 amp shunt
2 Ring Terminals
26.10 Component Parts list for Fuel Flow Transducer
1 fuel flow transducer, 201 or 231 PN 700900-1,-2
8 inches of 1.5” dia. fire sleeve
1 3-pin Molex connector housing
3 female pins Molex
2 AN816-4-4 fittings (Continental) or AN816-4-6 (Lycoming)
26.11 Component Parts list for MAP sensor KIT 1440
1 P/N 159934A Manifold pressure sensor
1 P/N 159961 Clamp, Loop Cushioned
1 P/N 174402 Connector Pack 3 Pin and Terminals
26.12 Components Parts list for non pressurized RPM sensor P/N depends on Magneto make and model
Bendix magneto -20, 1200………….P/N 420815-2
Slick magneto 4000 or 6000………P/N 420815-1
Bendix dual ………………………….P/N 420808
26.13 Components Parts list for pressurized RPM sensor P/N depends on Magneto make and model
Slick 6000………………………….….P/N 420809
Bendix magneto 20, slick 600………P/N 420806
Bendix Dual ………………………….P/N 420808
Bendix 1200………………………….P/N 420807
To Next Page
Loading...
Need help?
General
