USB DISPLAY ADAPTER USER MANUAL
11
A. Connect all external display devices (monitor/ projector) to the HDMI /DVI
connector of USB 3.0 Display Adapters and switch power on.
B. Connect the USB 3.0 Display Adapter into an available USB port of a PC or
Notebook.
After Inserting an USB 3.0 Display Adapter into a USB port, the systems will
automatically start the installation procedure and the prompt message will pop-up
on the task bar.
The Device driver software was installed properly,
if you are going to install more USB 3.0 Display Adapters, repeat step A& B or restart
computer.
The functions of the USB 3.0 Display Adapter will be activated after the computer
restarted. You might see the extend display shown on the display device.
You can modify the corresponding position of each extend display via display settings.
Go to “START” → “Control Panel” → “Appearance and Personalization” → “Adjust
screen resolution”
※ Right-click on the desktop and go to “Screen Resolution”
To Next Page
Loading...
