USB DISPLAY ADAPTER USER MANUAL
19
6. After your computer is rebooted, connect the external display device (monitor/
projector) to the HDMI/DVI connector of USB 3.0 Display Adapters and turn it on.
7. Connect the USB 3.0 Display Adapter into an available USB port of a PC or
Notebook, After Inserting the USB 3.0 Display Adapter into an USB port, the
“Installing device driver software” message will pop up.
An icon ( ) will be seen on the lower right toolbar.
The message pictures below shows Driver software is installed successfully.
If you’re not going to install another USB 3.0 Display Adapter, restart your PC. The
functions of the USB 3.0 Display Adapter will be activated after the computer restarted.
Multi-USB 3.0 Display Adapter Installation
For installation of multiple USB 3.0 Display Adapters, during the “Install Shield Wizard
complete” step, select “No, I will restart my computer later.” and click Finish to
continue next step below
To Next Page
Loading...
