Warranty: All products of the company are sold and all services of the company are offered subject to the company’s warranty and terms and conditions of sale, copies of which will be furnished upon request.
The information provided herein is for guidance only, it does not constitute a guarantee of the performance or specification of any individual product or component.
©Copyright 2000 ITT Industries - Jabsco
43010-0201
1. INTRODUCTION
1.01 Safety
1.02 Principle of operation
1.03 Operating conditions
1.04 Model numbering system
1.05 Inspection upon receipt
2. INSTALLATION
2.01 Operating limitations
2.02 Location & Positioning
2.03 Drives
2.04 Baseplate
2.05 Guards and safety
2.06 Electrical
2.07 Pipework
2.08 Enlarged rectangular inlet
2.09 Temperature control jackets
2.10 Seals and flushing
2.11 Seal materials
2.12 End Cover relief valve
2.13 End cover barrier
2.14 Overload protection
3. LUBRICATION
4. START UP & ROUTINE CHECKS
4.01 Start up
4.02 Daily Checks
4.03 Weekly Checks
4.04 Monthly Checks
4.05 Six Monthly Checks
4.06 Annual Checks
5. CLEANING AND STERILIZING
5.01 Cleaning in place (CIP) & Manual
cleaning
5.02 Sterilizing in place (SIP)
6. INSPECTION AND REPAIR
6.01 End cover
6.02 Rotors
6.03 Mechanical shaft seals - single primary
6.04 Mechanical shaft seals - single flushed
6.05 Mechanical shaft seals - double
6.06 Seal housings
6.07 Single o-ring seal
6.08 Double o-ring seal
6.09 Multi-Lip seal
6.10 Rotor case
6.11 Rotor clearance - checking &
adjustment
6.12 End cover relief valve
6.13 Thermal jacket –end cover
6.14 Thermal jacket –pump head
6.15 Thermal jacket –rotor case
6.16 Bearing housing - inspection & repair
6.17 Gearbox shafts and gears
6.18 Bearing set-up and pre-load
7. MODEL NUMBER BUILD CODE
8. PARTS LIST AND EXPLODED
DIAGRAMS
8.01 Parts List
8.02 Hy~Line Exploded Diagram
8.03 Ultima Exploded Diagram
8.04 Hy~Line 3 Size Sectional View
8.05 Options & Extras - Sectional Views
DECLARATION OF INCORPORATION
07/03
Hy~Line and Ultima Lobe Pumps
Contents
To Next Page
Loading...
Need help?
General
