English
Any maintenance work or replacement of parts must be carried out by a qualified individual.
6 CONTROLS AND SAFETY FEATURES
6.1 Controls:
Your slicer is fitted with two buttons as standard:
A start button and an emergency stop button.
It may be fitted with the following additional buttons as an option:
- Pressure selector.
- Auto mode.
- Blower start (on machines equipped with a blower).
6.2 Work area:
The work area is at the front of the machine (fig.3, n°18).
6.3 Safety features:
This machine is equipped with:
A mechanical safety switch (fig. 10, n°23) (EPK – EPF – EPKS – EPFS – EGK – EGF)
Located at the back of the top cover
Which stops the machine when the top cover is opened (fig.1, n°2).
A mechanical safety switch (fig. 11, n°24)
Located at the bottom of the machine, under the crumb tray
Which prevents the machine form starting when the front door is opened (fig.1, n°8).
Photoelectric cells that prevent the machine from operating when the beam is broken (optional)
(EPL – EPM – EPLS – EPMS – EGL – EGM) (fig.8, n°21).
A safety bar that stops the machine from operating when pressed
(optional) (EPB – EPBS – EPN – EPNS).
7 OPERATION
Braked castors must be locked while the machine is in operation (fig.1, n°13).
Switch on the power to the machine at the start of the day using the emergency stop
(fig.1, n°10).
Operating procedure
OPTIONAL: Select type of control using the selector button (fig.4):
1: low speed
2: high speed
ISC: automatic management
To Next Page
Loading...
