Jack A4 - Operating Instructions: Monitoring Parameters; Monitoring Parameter Overview

Parameter description
Parameter
Adjustable
range
System
default
26
27
B
C
Language selection
0: language off.
1: Chinese. 2: English
P99
0/1/2
1
Language setting Mounting and dismounting of motor encoder
Operation Sequence:
1. Take down the hand wheel and then utilize hex key(4mm)
to loose four electric control fastening screws (represented as AB
in the picture).
2. Take down the electronic control box and then use hex key
(4mm) to loose the screw (represented as C in the lower left
corner of the picture).
3. Loose 2 motor encoder fastening screws by the hex key
and take down the upper part of housing, then remove the motor
encoder.
Manual Book of A4
Product Introduction
The screw must be
removed first
Downward