Jack JK-T1377E - Page 17

- 17 -
3.1 The technician parameter table
Note: 16 x parameter operation is to be a long time holding down the key
about 3 to 5 seconds.
1.Long press , can modify the technician parameter table;
2.Press the corresponding key and or and keys can choose
parameter number and change the corresponding parameter values;
3.Finally to press the key , exit parameters setting mode, back to the
sewing pattern.
The serial
number
range
Typical
values
Parameters to describe
note
100
100~ 800
200
The sewing speed
speed
101
200~ 1500
1500
The maximum speed limit on free
seam top speed (global)
104
200~ 800
400
Reset speed
108
100~ 800
400
Sewing speed slow
13A
0~800
300
Pedal presser foot set the time
Pedal
speed
paramet
er
13E
0~800
10
Presser foot lift the delay time
140
0~2
1
Electricity automatically find a
parking space: 0: don't look for;
1: find a ；2：automatically find
Used to
set
149
0~10
0
Presser foot slowly let go off (0
closed slowly, non-zero for slow
opening)
164
-
password
165
XXXX
7001
Restore the factory Settings