Jacobsen AR3

GB-10
JACOBSEN AR3
NARROW WIDTH OF CUT FIELD KIT
FITTING INSTRUCTIONS
5 CENTRE LIFT ARM
5.1 REMOVE CUTTING UNIT FROM LIFT ARM
1. Remove M8 x 55 Cap Screw (D), M8
Lockwasher (E) and Clamp Collar (C) from Lift
Arm (A).
2. Detach Cutting Unit from Lift Arm (A).
3. Remove Thrust Washer (B) from Lift Arm (A)
Pivot Shaft.
4. Retain items (B), (C), (D) and (E) for future use.
5. Remove Stop Bracket (F) from Mainframe.
6. Retain items (J), (K) and (L) for future use.
7. Remove Rubber Buffer (G) from Stop Bracket
(F).
8. Retain items (G) and (H) for future use.
5.2 DISCONNECT LIFT RAM FROM LIFT ARM
1. Remove Ram Pin (B) from Lift Arm (A).
2. Retain Ram Pin (B) and all hardware (C, D and
E) for future use.