GB-6
JACOBSEN AR3
NARROW WIDTH OF CUT FIELD KIT
FITTING INSTRUCTIONS
3 PREPARATION
3.1 PREPARATION
CAUTION: Read the tractor’s manual and
become familiar with the tractor, the controls and
proper use of the equipment.
Stay alert for potential hazards and follow all
safety precautions. Read all instructions
completely and make sure you understand them
before proceeding with the assembly
1. Park the tractor on a flat and level surface, fully
lower the implements to the ground, engage
parking brake, stop the engine and remove key
from ignition switch.
a. Wait for all movement to stop before
making any adjustments or
modifications.
b. Take this opportunity to thoroughly
inspect the equipment and perform other
maintenance.
The “Right” and “Left”, “Front” and “Rear” of the
machine are referenced from the operator’s right and
left when seated in the operator’s seat facing the
direction of forward travel.
3.2 IMPORTANT NOTE
1. It is not necessary to break any hydraulic
connections when fitting this Field Kit.
2. This modification will reduce the protential for
feathering on side slopes. However it also
reduces the width of cut from 1.82m (72in) to
1.7m (67in).
To Next Page
Loading...
Need help?
General
