B
en-56
Safety, Operation, & Maintenance Manual
OPERATION
Lithium
DAILY MAINTENANCE________________________________________________
IMPORTANT: For more detailed maintenance information, adjustments and maintenance/lubrication charts,
see the Parts & Maintenance manual.
1. Park the mower on a flat, level surface. Fully lower the reels to the ground, stop the engine and remove key from
ignition switch.
2. Grease and lubricate all points if required. Lubricate with grease that meets or exceeds NLGI Grade 2 LB specifica-
tions. Apply grease with a manual grease gun and fill slowly until grease begins to seep out. Do not use compressed
air.
3. To prevent fires, clean the reels and mower after each use.
• Whenever possible, use compressed air to clean mower.
• Use only fresh water for cleaning your equipment.
• Do not pressure wash mower.
• Do not spray water directly at instrument panel, electrical connectors, generator, controllers, motors, or any other
electrical components.
• Do not spray water into the cooling air intake or the engine air intake.
• Clean all plastic or rubber components with a mild soap solution and warm water, or use commercially available
vinyl/rubber cleaners.
4. Remove any dirt or other debris from both steering proximity switches.
Battery Powered Mowers:
• Disconnect power connector and connect battery pack to charger.
NOTICE
To prevent damage to reel motor, do not over-
grease reel bearings. Damage of this nature is not
covered by the factory warranty.
NOTICE
Use of salt water or effluent water has been known
to encourage rust and corrosion of metal parts
resulting in premature deterioration or failure. Dam-
age of this nature is not covered by the factory war-
ranty.
NOTICE
Do not use high pressure spray.
NOTICE
Do not wash a hot or running engine. Use com-
pressed air to clean the mower, engine and radiator
fins to reduce the potential for corrosion and mois-
ture contamination.
To Next Page
Loading...
Need help?
General
