Jacobsen ECLIPSE 360 - Headlight Adjustment; Steering Sensor Adjustment

B
ADJUSTMENTS
en-85
Safety, Operation, & Maintenance Manual
Lithium
HEADLIGHT ADJUSTMENT ___________________________________________
Headlight has four adjustment positions to change distance head light beam lights up. To Adjust headlight:
1. Remove access plug (AM) from left side of steering col-
umn.
2. Raise or lower adjustment tab (AN) until headlight
latches in desired detent position.
3. Insert access plug.
STEERING SENSOR ADJUSTMENT
1. Open hood and remove controller cover.
2. Loosen controller brace hardware (ZA).
3. Adjust position of controller brace (ZD) as required to
allow an air gap of 1/8 to 3/16 in. (0.32 to 0.48 cm)
between magnetic portion of sensor (ZB) and sensor
body (ZC). Torque hardware (ZA) to 53 in. lb. (6 Nm).
AN
AM
1/8 - 3/16 in.
(0.32 - 0.48 cm)
ZA
ZB
ZC
ZD
ZD