B
ADJUSTMENTS
en-83
Safety, Operation, & Maintenance Manual
Lithium
ARMREST HEIGHT ADJUSTMENT ______________________________________
The armrest has three available height settings for operator
convenience. To adjust armrest height:
1. Shut mower off and remove key.
2. Remove three bolts (V) from bracket on right side of seat.
3. Raise or lower armrest as needed until another set of
holes in armrest bracket line up with seat bracket.
Assemble hardware (V).
4. After adjusting height, check three armrest wire harness
connectors for a tight connection to main harness.
ARMREST PIVOT ____________________________________________________
1. Tighten or loosen pivot plunger (W) as required so
plunger button stops the armrest at both ends of armrest
pivot slots, and plunger body does not contact armrest
pivot. Do not use plunger to increase pivot tension.
2. Adjust hardware (X) as required to obtain 2 to 6 lbs (9 to
26.7 N) of force required, at visor end of armrest, to pivot
armrest. Do not overtighten pivot hardware or leave too
loose.
GRASS CATCHER YOKE ADJUSTMENT
1. Loosen hardware (AT).
2. Adjust yoke (AU) as required so lip of grass catcher is
resting on reel crossbar (AV).
3. Tighten hardware (AT).
AU
AU
AT
AT
AT
AT
AV
To Next Page
Loading...
Need help?
General
