3-18 4241262-Rev B
ENGINE
3
Installation Notes
• Inspect engine mounts, and replace if necessary.
• Install engine by reversing order of removal.
• If necessary, remove components from engine and
install components on new engine.
• Apply dielectric grease (Jacobsen PN 365422) to any
wire connectors disconnected.
• Use new exhaust gasket when installing exhaust
system.
• Fill radiator with clean water and ethylene glycol
based antifreeze mixed for coldest ambient
temperature.
• Replace engine oil filter and fill engine with oil.
• Purge air from fuel system. (See “Purging the Fuel
System” on page 3-5.)
Engine Service
A separate engine manual, prepared by engine
manufacturer, is supplied with this machine. Refer to
engine manufacturer’s manual for all engine-related
service.
Proper attention to engine manufacturer’s manual
directions will ensure maximum service life of engine.