16
600 Series
Turfcat
Tractors
FUEL FILTER
1. To change the fuel filter only, first remove the see-
through water separator bowl. See water fuel
separator procedure on the previous page.
2. Remove the large black retaining ring G.
3. Pull the filter element straight down. Do not twist
as the filter element is not threaded.
4. Dispose the old filter element according to local
laws.
5. Align key in filter element with the slot in the
header and push the new filter element up into the
filter head.
6. Place retainer ring G. Hand tighten retainer ring
until it clicks and the arrows line up in the center
of the header.
7. Replace the water fuel separator.
NOTE: Always bleed the fuel system of air after
changing the fuel filter.
HYDRAULIC NOTES
– Lower implements attached to lift arms to relieve hydraulic pressure from system before servicing.
– When servicing hydraulic pipe fittings, do not use teflon tape. Use a liquid sealant that will dissolve into
the system.
– Make sure all hydraulic connections are tight before applying pressure to system.
When checking for leaks, do not use your hands to attempt to feel a spray. Instead, pass an object like
cardboard over hydraulic system components to visualize a spray. Escaping hydraulic fluid can be under
sufficient pressure to penetrate skin and cause serious injury. If injured by escaping hydraulic fluid, see a
doctor at once. Serious infection or reaction can develop if proper medical treatment is not administered
immediately.
MAINTENANCE
To Next Page
Loading...
Need help?
General
