ADJUSTMENTS 3
en-11
3.3 ALTERNATOR BELT _______________________________________________________
Depress the be lt at th e center between the crankshaft
and alternator pulleys with a force of 11 lbs. (5 kg). The
belt should deflect approximately 0.2 in. (5 mm).
1. Loosen the pivot bolt at the base of the alternator.
2. Loosen the to p bolt (E) and rotate the al ternator
along the guide to i ncrease or decrease the belt
tension.
3. While holding the alternator at this location, tighten
bolt (E).
4. Tighten the pivot bolt.
5. Verify belt tension and repeat adjustment if required.
Figure 3C
3.4 REAR WHEEL ADJUSTMENTS_______________________________________________
To adjust wheel toe-in:
The rear wheels should be 1/8 i n. (3.2 mm) closer
together at the front than at the back of the wheels.
1. Loosen locknuts (F) at ea ch ball joint near the rear
wheels.
2. Rotate tie r od (G) until the wheel is correctly
positioned.
3. Tighten locknuts (F).
To adjust steering shaft:
Loosen nut (H) and rotate steering shaft in cylinder to
provide full steering right and left. Side of arm (J) should
contact pin (K). Check both sides.
Figure 3D
To Next Page
Loading...
