4/53
SAVE THESE INSTRUCTIONS: This manual contains important
safety instructions for the proper use and maintenance of this
product.
1. Introduction
SAFETY GUIDELINES DEFINITIONS
This manual contains information for the proper assembly, op-
eration and care of your sprayer. Carefully read and follow the
instructions contained in this manual before using your sprayer.
This equipment was designed for spraying plants protection
products approved by regulatory authorities to be used in knap-
sack sprayers.
It is important for you to read and understand this manual. The infor-
mation it contains relates to protecting YOUR SAFETY and PREVENTING
PROBLEMS. The symbols below are used to help you recognize this in-
formation.
2. Specifications
Notice: Used without the safety alert symbol indicates a potentially haz-
ardous situation which, if not avoided, may result in property damage.
DANGER!
Indicates an imminently hazardous situation which, if not avoid-
ed, will result in death or serious injury.
WARNING!
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION!
Indicates a potentially hazardous situation which, if not avoided,
may result in minor or moderate injury.
3.1. Unpacking
3. Preparing the Product For Use
Take out of the sprayer carton the following parts:
CAUTION!
Be careful when taking out the sprayer out
of the carton because the lever is loose and
can cause damage or personal injury. Note
that the agitator is loose inside the tank and
must be properly assembly.
NOTE: Carton can be discarded in recyclable waste.
NOTE: Minimum space needed for use, maintenance and repair
is 1,5 m².
Model PJ-16
Net weight 4.9 kg
Gross weight 5.3 kg
Spray lance length 600 mm
Hose length 1350 mm
Chemical tank
Capacity 16 l
Filling opening diameter 105 mm
Material Polyethylene
Pump
Type Piston
Maximum working pressure 6.8 bar
Nozzle installed Blue adjustable cone
Material Brass
• Open the tank lid and visualize the agitator;
• With one hand pull up the chamber, but without removing
it from the tank, up to the level it will be possible to t the
agitator in its body (Image A). With the other hand, t the ag-
itator and make sure it is rm and tight;
• Lower the chamber with the agitator assembled until it ts in
the cylinder (image B).
(A) (B)
Rod
Tank
Lance
Accessories plastic bag
Contents of the plastic bag
Lever
Manual
Trigger Valve
3.2. Installing the shaft
• Fit the shaft (1) into the free orice on the
• sprayer base (chamber side).
• Use a plastic hammer to strike the shaft smoothly until the
hole on the shaft end matches the hole on the base reinforce-
To Next Page
Loading...
Need help?
General
