J-200
3.3 Important Safety Instructions
When using this electrical equipment, basic safety precautions should
always be followed, including the following:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. A green colored terminal or a terminal marked G, Gr, Ground,
Grounding or the symbol* is located inside the supply terminal box
or compartment. To reduce the risk of electric shock, this terminal
must be connected to the grounding means provided in the electric
supply service panel with a continuous copper wire equivalent in size
to the circuit conductors that supply this equipment (*IEC Publication
417, Symbol 5019).
3. At least two lugs marked “Bonding Lugs” are provided on the
external surface or on the inside of the supply terminal box/
compartment. To reduce the risk of electric shock, connect the local
common bonding grid in the area of the spa to these terminals with
an insulated or bare copper conductor not smaller than No. 6 AWG
(10 mm²).
4. All eld installed metal components such as rails, ladders, drains or
other similar hardware within 10 feet (3m) of the spa shall be bonded
to the equipment grounding buss with copper conductors not smaller
than No. 6 AWG (10 mm²).
5. SAVE THESE INSTRUCTIONS.
3.4 PRECAUTIONS-Important Chemical Safety
Do not use this device with bromide products.
3.5 PRECAUTIONS FOR USE OF PRODUCTS CONTAINING
SODIUM BROMIDE
• Do not use any Product containing Sodium Bromide with an
electrolysis device (for example, a chlorine generator).
• Do not use any Product containing Sodium Bromide with ozonation.
• Do not use any Product containing Sodium Bromide with ultraviolet
(UV).
9
To Next Page
Loading...
