Jacuzzi J-200 - Control Functions; Control Panel Buttons; Control Panel Display Icons

J-200
9.0 Control Functions
9.1 Control Panel Buttons
A. LCD Display: Can display current wa-
ter temperature (default display), water
temperature set point, selected menu
functions, and error messages.
B. Warmer Button (
): Increases water temperature set point.
Increments of 1°F or 0.5°C.
C. Cooler Button (
): Decreases water temperature set point.
Increments of 1°F or 0.5°C.
D. Jets 1 Button (
1
): Turns jets pump #1 on and off. Press once for
low speed; press a second time for high speed; press a third time to
turn pump off.
E. Jets 2 Button (
2
): Turns high-speed jets pump #2 on and off.
Press once to turn pump #2 on; press a second time to turn pump #2
off.
F. Menu Button (
): Allows access to the programming menus.
G. Light Button (
): Turns on the accent lights in one of three ran-
dom modes or one of seven solid colors. Turns on the exterior lights
in a white color only. Refer to Section 10.3 (page 29) for details.
9.2 Control Panel Display Icons
A.
(Heat icon): Displayed when the heater is on. Flashing while the
heater adjusts to temperature changes.
B. (Ready Mode icon): Allows the hot tub to heat to a set temperature.
C. (Rest Mode icon): Allows the hot tub to heat only during a filtration
cycle. The spa will reach to a set temperature only in a filtration.
D.
(Light icon): Displays when the lights are on.
E. (Cleanup Cycle icon): Displays when a cleanup cycle is active,
page 30.
F. (Jets 1 icon): Displays when Jets pump 1 is on. Press once for
low speed; press again for high speed. The pump activates for
20-minute then turns off.
A
B
C
D
E
F
G
2
1
2-pump control panel shown
25