Jacuzzi J-200 - 4.0 Choosing A Location

J-200
4.0 Choosing A Location
IMPORTANT: Because of the combined weight of the spa, water and
users, it is extremely important that the base upon which the spa rests
be smooth, at, level and capable of uniformly supporting this weight,
without shifting or settling, for the entire time the spa is in place. Visit
www.Jacuzzi.com for weight information. If the spa is placed on a
surface which does not meet these requirements, damage to the skirt
and/or the spa shell may result. Damage caused by improper support
is not covered under warranty. It is the responsibility of the spa owner
to assure the integrity of the support at all times. We recommend a
poured, reinforced concrete slab with a minimum thickness of 4 inches
(10 cm). Wood decking is also acceptable provided it is constructed so
that it meets the requirements outlined above.
WARNING: For spas that are to rest on balconies,
roofs or other platforms not specically tied into main
structural support, consult a professional Structural
Engineer with experience in this type of application.
!
WARNING: Proper drainage is required. The installation
must not allow the spa equipment bay to become ooded
or wetted (by external water). It is your responsibility, and
the responsibility of any installation contractor you hire, to
make sure that all applicable codes and/or local construction
requirements are met. If in doubt, refer to the building authority
responsible for approving the proposed installation site.
!
The spa must be installed in such a manner as to provide drainage away
from it. Placing the spa in a depression without provisions for proper
drainage could allow rain, overow, leaks from spa plumbing, and other
casual water to ood the equipment and create a wet condition in which
it would sit in. For spas which will be installed below grade or recessed
into a oor or deck, install so as to permit access to the equipment, either
from above or below, for servicing. Make certain that there are no
obstructions which would prevent removal of all side cabinet side panels
and access to the jet components, especially on the side with the
equipment bay.
CAUTION: If the spa is indoors or located in an enclosed area,
proper ventilation should be discussed with an Engineer or authority
competent enough to understand the necessary provisions needed
to vent moist or heated air and air associated with chemical odors
outdoors. When the spa is in use considerable amounts of
moisture will escape potentially causing mold and mildew. This
can cause health risk. Over time, this can damage certain surfaces,
surroundings, and equipment.
!
10