Jacuzzi J-200 - 11.2 Programming the Mode Setting

J-200
1. Press the or button to adjust the set temperature. The
temperature numbers will start ashing to show the system is ready
for adjustments. Once set to the preferred temperature, press to
program the change and return to the Main Menu.
B. Switching between high and low temperature ranges.
1. From the Main Menu, press the button to enter the Temperature
Menu. Press the or button to toggle between the ranges,
or . Once you select the desired range, press to program the
change and return to the Main Menu.
C. Low Range Temperature
The low range settings are between 65°F (18.5°C) and 99°F
(37°C). When the spa is in this setting it will display this icon
. This setting is normally used as an away program. To adjust the
temperature, follow the steps below.
Note: If no button is pressed within 5 seconds of each selection the
screen will revert back to the Main Menu and the current settings will
remain active.
1. Press the or button to adjust the set temperature. The
temperature numbers will start ashing to show the system is ready
for adjustments. Once set to the preferred temperature, press to
program the change.
11.2 Programming the Mode Setting
Your hot tub is equipped with 2 modes of heating. A “READY” mode,
where the hot tub’s temperature is maintained at all times. A “REST”
mode, where the hot tub only heats during a lter cycle.
A. Ready Mode
Allows the heater to heat, at all times, in order to maintain the preset
temperature. Indicated by the Ready Mode “ ” icon on the Main Menu
display. Pump 1 low speed activates periodically to circulate the water
and determine the spa temperature.
B. Rest Mode
Allows the heater to heat only during a programmed lter cycle. Indicated
by the Rest Mode “ ” icon on the Main Menu display. If the primary pump
has not turned on within an hour, the message “RUN PUMP FOR TEMP
-- -- -- --” will appear on the display. Pressing the Jets Pump 2 button
will active the pump and heater so the temperature can be sensed and
displayed.
C. Switching between Ready and Rest Mode
From the Main Menu, press the button twice to enter the Mode Menu.
Press the or button to toggle between Ready Mode “ ” and Rest
Mode “ ”. Once the mode is selected, press to accept the change
and return to the Main Menu.
33